SecurityInsight settings · Settings > Guards
Failed step: show what was collected all the same
| Key | SI_Pro_Pipeline_GoOnAfterFailedStep |
|---|---|
| Where | Settings > Guards (safety checks) > Data-quality warnings |
| Type | On / off |
| Default | On |
| Edition | pro |
What it does
When the correlation or Risk Analysis fails after the collections completed, the data sync and the verification still run on what is stored, so the web app shows what was collected instead of nothing. The run is marked as not complete and says what is missing.
When enabled
On is the default: it works as described under "What it does".
When disabled
Off holds every step after a failed one until the next good run, as before: a new install then shows nothing until its first run completes. On or off, nothing is closed, no ticket is changed and no mail is sent from a run that is not complete.
Risk and how to reverse it
Off: after one failed step the web app gets nothing from that run -- a new install stays empty until its first run completes. On: the web app shows what the completed collections brought, marked as not complete. Either way nothing is closed, no ticket is changed and no mail is sent from a run that is not complete. Reversible at once; it applies from the next run.
Requires
A SecurityInsight Pro licence.
Recommended
Keep the default. Change it when: Leave it on. Turn it off only if the web app must never show data of a run in which a step failed.
Documented for SecurityInsight 3.0.79. Written by the SecurityInsight team; Invardia publishes it. · All settings · Security review pack