SecurityInsight settings · Settings > Guards
Vulnerabilities: target not read in full
| Key | SI_Guard_VulnConnectorTargetIncomplete_Enabled |
|---|---|
| Where | Settings > Guards (safety checks) > Vulnerability connector checks |
| Type | On / off |
| Default | On |
| Edition | Community |
| Confirmation | SecurityInsight asks you to confirm before it is switched off. |
What it does
The safety check that protects your vulnerability target from duplicate records: The vulnerability target (for example the ServiceNow table) could not be read in full, so nothing was written: every record the read missed would have been opened again as a duplicate.
When enabled
the check works as described on the Guards page.
When disabled
no event and no mail. The step itself still stops, because writing after a partial read of the target would open every record the read missed again as a duplicate.
Risk and how to reverse it
Turning this check off removes a protection: when its condition happens, nothing holds or stops the step and no event is raised. Reversible at once: switch it back on; it applies from the next run.
Requires
Works only while "All guards (safety checks)" is on.
Recommended
Keep it on. Change it when: Leave it on. Turn it off only when this check keeps stopping work you know is right -- read what Off means first.
Documented for SecurityInsight 3.0.79. Written by the SecurityInsight team; Invardia publishes it. · All settings · Security review pack