SecurityInsight settings · Settings > Guards
Vulnerabilities: Risk Analysis run not finished: mail
| Key | SI_Guard_VulnConnectorRunIncomplete_Mail |
|---|---|
| Where | Settings > Guards (safety checks) > Vulnerability connector checks |
| Type | On / off |
| Default | On (follows the check: nothing is mailed while the check is off) |
| Edition | Community |
| Confirmation | SecurityInsight asks you to confirm before it is switched off. |
What it does
Whether this safety check sends a mail when it trips.
When enabled
(follows the check: nothing is mailed while the check is off)
When disabled
the event is still shown on the Guards page and kept in run health and the audit trail, but no mail is sent for it. The install-wide switch "Mail when a safety check stops a step" still applies to every check.
Risk and how to reverse it
Low: no data is changed and the check still works; only its mail stops, so a trip is seen only on the Guards page, in run health and in the audit trail. Reversible at once.
Requires
Works only while "Vulnerabilities: Risk Analysis run not finished" is on.
Recommended
Keep the default. Change it when: Turn it off for a check whose mails you do not need, instead of turning the check off.
Documented for SecurityInsight 3.0.79. Written by the SecurityInsight team; Invardia publishes it. · All settings · Security review pack