SecurityInsight settings · Settings > Schedules & what runs

CI build: time limit for the rules of one asset

Key	SI_CiRulesBudgetSeconds
Where	Settings > Schedules & what runs > Daily pipeline
Type	int
Default	60 seconds per asset
Edition	Community

What it does

How long the rules of one asset may take in the CI build (correlation) before the build goes on with the next asset. Applying the rules to one asset normally takes milliseconds; an asset with unusually large data could otherwise hold the whole build, and with it every step after it.

When set

An asset that takes longer is not fully evaluated in that run. Nothing of the half evaluation is stored: Risk Analysis and the views keep what the asset had from its last complete evaluation, and a new asset is left out until it is fully evaluated. It is named in the run log, counted ("N asset(s) not fully evaluated in this run") and evaluated again in the next run. A higher value gives a slow asset more time; 0 removes the limit, and one asset can then hold the build for as long as its rules take.

When blank or default

Left blank, the default applies: 60 seconds per asset

Risk and how to reverse it

None to the data either way: an asset that is not fully evaluated keeps its last complete result, and no tier or finding is based on part of the rules. A very high value, or 0, lets one asset hold the build and with it the steps after it. Reversible at once.

Requires

Nothing else.